SFP-10G-TS 10GBASE-T Copper SFP+ Transceiver, RJ-45, 30m
- 10GBASE-T 10 Gigabit Ethernet
- RJ-45 copper connection; up to 30m on Cat 6a/7
- Hot-pluggable SFP+ form factor
- 0°C to +70°C operating case temperature
Host requirement: Verify SFP+ 10GBASE-T copper-module compatibility and power/thermal budget.
$42.99
200 in stock
200 in stock
Description
Product Overview
SFP-10G-TS is a hot-pluggable 10GBASE-T copper SFP+ transceiver that provides a 10 Gigabit Ethernet RJ-45 connection over Cat 6a or Cat 7 twisted-pair copper cabling, with a maximum reach of 30m.
It is intended for network switches and equipment with SFP+ ports that explicitly support 10GBASE-T copper transceivers.
Connection & Selection Guide
Typical connection: Compatible 10G SFP+ host → SFP-10G-TS → RJ-45 Cat 6a/7 cable → 10GBASE-T network device (up to 30m).
Before ordering: Confirm host support for 10GBASE-T SFP+ modules, available power and heat budget, port speed, and vendor coding. An SFP+ slot alone does not guarantee compatibility.
Technical Support & After-Sales
For compatibility checks or product documentation, contact support@sailtel.com with the exact host model.
See our Shipping, Returns & Refunds policy for service terms.
Technical Specifications
Overview
| Model | SFP-10G-TS |
|---|---|
| Ethernet Standard | 10GBASE-T |
| Data Rate | 10Gbps |
| Form Factor | SFP+ |
| Connector | RJ-45 |
| Cable Type | Cat 6a / Cat 7 |
| Maximum Reach | 30m |
| Operating Case Temperature | 0°C to +70°C |
| Hot-Pluggable | Yes |
| Housing | Metal enclosure |
| Serial Interface | 2-wire serial |
| Host Compatibility | 10GBASE-T-compatible SFP+ port |
Datasheet & Downloads
Frequently Asked Questions
What is the maximum supported distance?
Up to 10km on suitable single-mode fiber, subject to the link budget and connector loss.
Which optical wavelength and connector does it use?
A nominal 1310nm optical wavelength and duplex LC interface.
Is the module compatible with multimode fiber?
This model is specified for single-mode fiber. Select an appropriate multimode transceiver if your installation uses MMF.
What speed does it support?
It is designed for 10GBASE-LR applications at a 10.3125Gbps line rate, not for 1G SFP operation.
Does it support DDM / DOM?
Yes. Digital diagnostic monitoring is supported when the host equipment exposes these readings.
Can I insert it while equipment is powered on?
Yes, in a compatible hot-pluggable SFP+ host. Follow your device manufacturer's procedures.
Will it work with any brand of switch?
Not automatically. Check the host brand, model, firmware and vendor coding requirements before ordering.
Reviews
Clear filtersThere are no reviews yet.